Using your left hand, push down with your thumb on the top most cartridge. ![]() Next, place the stripper clip (either end) into the charger slots on the top of the barrel extension. The first step is to cock the hammer and pull the bolt back and it will lock into place (being held by the magazine follower). Note the slot where the stripper clip is inserted on the right. Looking down on the magazine well of the pistol, the magazine follower locks the bolt back when either the pistol is being first loaded or when you have shot it empty. NOTE: THESE ARE DUMMY ROUNDS USED FOR EXAMPLE ONLY When loading the stripper clip, the grooves of the clip slide onto the rim of the case and holds it snugly in place. Depending on the caliber of the weapon will determine which type of clip you will need, although the 9mm seems to fit the. They are, of course, not interchangeable. The metal clips (available from Sarco and other parts suppliers) look like your typical rifle charging clips, very closely in fact, like the chargers used for the M16 rifle. The correct way of loading the pistol is by the use of a 10 round stripper clip. Because the bolt is being held back by the follower of the magazine, you cannot easily nor safely load the magazine singly. ![]() The C96 has an internal magazine that holds 10 rounds in a staggered column. Adobe PDF Downloadable Version of Article
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |